Product introduction
Material: single-componentpolymer film, multi-component polymer composite film.
Type: non-porous, multi-microporous.
Material Properties: Natural properties, enhanced or altered.
Function:
*Sensible heat exchange:recovery of cold energy & heat energy.
*Latent heat exchange:humidification & dehumidification
*Full heat exchange: recovery ofcold energy & heat energy. Simultaneous humidification &dehumidification
Applicable media: gas-gas, liquid-gas, flow dynamics.
Working conditions: There is a certain temperature & humidity difference betweenthe two media.
Product advantages: (compared to conventional similar membranes on the market)
Application advantages
1. It will not cause air pollution due to dampness and mildew.
2. The air will not be mixed during the exchange. It will not cause pollution and virus transmission.
3. The porous membrane is very thin. The energy exchange rate and recovery rate are higher. At the same time, the humidity can be reasonably controlled.
4. Membrane cost is lower than other materials. Long service life.
5. Washable and ETO sterilized. Maintenance and replacement are easy.
6. The material is environmentally friendly. No harmful substances are released.
Product parameters
Remark:
◆ The above data are typical values tested under certain conditions. For reference only.
◆ Membrane thickness/pore size/actual temperature and humidity difference/pressure may affect relevant data.
◆ Membrane usage environment/air quality may affect actual data.
◆ Environmental and usage conditions may cause mildew or condensation on the membrane surface. Please consult and choose our membranes with corresponding functions.
Application: (Manufacture of total heat exchanger)
1. Recover the energy of the cold gas or warm gas in the building. At the same time, it is used for the temperature and humidity regulation of the intake air. Reuse and reduce energy consumption.
2. The thermal energy used for factory boiler steam and production line exhaust gas is recovered and reused. Reduce waste caused by direct emissions.
3. It is used for the treatment of the exhaust air of the Refrigeration warehouse. The cold energy is recovered and used for pre-cooling and humidity conditioning of the intake air. Reduce cooling energy loss.
Product data download
